Renesas Starter Kit+ for RZ/T2M

Overview

The Renesas Starter Kit+ for RZ/T2M is an evaluation and development kit for the RZ/T2M MPU. The board is powered through a 5V input via a DC Power Jack or USB Type-C Connector.

Hardware

The board utilizes the SoC of part no. R9A07G075M24GBG, with 2MB of RAM.

It has several on-board memory components: * SDRAM (256MBit), * NOR Flash (256MBit), * Octa Flash (512MBit), * HyperRAM (512Mbit), * QSPI Serial Flash (512Mbit), * I2C EEPROM (32Kbit).

The communication interfaces include: * Debug interfaces (J-Link, MIPI-10, MIPI-20), * Ethernet, * CAN, * USB, * RS485, * UART, * I2C, * SPI.

Supported Features

Interface	Controller	Driver/Component
NVIC	on-chip	nested vector interrupt controller
SYSTICK	on-chip	systick
PINCTRL	on-chip	pinctrl
UART	on-chip	serial
GPIO	on-chip	gpio

Other hardware features are not currently supported by the port.

Connections and IOs

By default, the board is configured for use with: * UART0 connected to the USB serial port (pins K18, K19), * UART3 connected to the PMOD Header (J25, pins H16, G20), * LEDs defined as led0, led1, led2 and led3,

The Zephyr console uses UART0.

Programming and Debugging

Debugging

Connect to the board using the J-Link On-board USB connector. Use west to start the debug server:

west debugserver

Connect GDB to the server and load an application:

target remote :2331
file build/zephyr/zephyr.elf
load