Musca-B1 Platform Specifics¶
DAPLink Firmware¶
The code on Musca-B1 is running from embededed flash. Make sure that the DAPLink FW for eFlash is downloaded to the board. You can find on the Arm Community page A short description of how to update the DAPLink FW can be found there as well.
Note
Warm reset of eFlash is not supported on Musca_B1. TF-M may not boot after a warm reset. Further information on the hardware limitation can be found on Arm Community page.
Platform pin service¶
This service is designed to perform secure pin services of the platform (e.g alternate function setting, pin mode setting, etc). The service uses the IOCTL API of TF-M’s Platform Service, which allows the non-secure application to make pin service requests on Musca B1 based on a generic service request delivery mechanism.
Copyright (c) 2017-2020, Arm Limited. All rights reserved.