nRF9160: SMS
The SMS sample demonstrates how you can send and receive SMS messages with your nRF9160-based device.
Requirements
The sample supports the following development kit:
Hardware platforms |
PCA |
Board name |
Build target |
|---|---|---|---|
PCA10090 |
|
When built for an _ns build target, the sample is configured to compile and run as a non-secure application.
Therefore, it automatically includes Trusted Firmware-M that prepares the required peripherals and secure services to be available for the application.
Overview
The SMS sample registers the nRF9160-based device for SMS service within the nRF9160 modem using the SMS subscriber library. The sample requires an LTE connection.
When the sample starts, it sends an SMS if a recipient phone number is set in the configuration. The sample then receives all the SMS messages and displays the information about the messages including the text that is sent.
Configuration
See Configuring your application for information about how to permanently or temporarily change the configuration.
Configuration options
Check and configure the following configuration option for the sample:
- CONFIG_SMS_SEND_PHONE_NUMBER - Configuration for recipient phone number in international format
The sample configuration is used to set the recipient phone number in international format if you need to send an SMS.
Additional configuration
Check and configure the following mandatory library options that are used by the sample:
Check and configure the following optional library options that are used by the sample:
Building and running
This sample can be found under samples/nrf9160/sms in the nRF Connect SDK folder structure.
When built as a non-secure firmware image for the _ns build target, the sample automatically includes the Trusted Firmware-M (TF-M).
See Building and programming an application for information about how to build and program the application and Testing and debugging an application for general information about testing and debugging in the nRF Connect SDK.
Testing
After programming the sample to your development kit, test it by performing the following steps:
Connect the kit to the computer using a USB cable. The kit is assigned a COM port (Windows) or ttyACM device (Linux), which is visible in the Device Manager.
Connect to the kit with a terminal emulator (for example, PuTTY). See How to connect with PuTTY for the required settings.
Observe that the sample shows the UART output from the device. Note that this is an example, and the output need not be identical to your observed output.
Send an SMS message to the number associated with the SIM card that you have placed into your nRF9160-based device.
Note
Not all IoT SIM cards support SMS service. You must check with your operator if the SMS service does not work as expected.
Sample output
The following output is logged in the terminal:
*** Booting Zephyr OS build v2.4.99-ncs1-1818-g54dea0b2b530 ***
SMS sample starting
SMS sample is ready for receiving messages
Sending SMS: number=1234567890, text="SMS sample: testing"
SMS status report received
SMS received:
Time: 21-04-12 15:42:52
Text: 'Testing'
Length: 7
Dependencies
This sample uses the following nRF Connect SDK library:
It uses the following sdk-nrfxlib library:
The sample also uses the following secure firmware component: