nRF51 SDK - S110 SoftDevice
|
This command copies a new BootLoader. With this command, destination of BootLoader is always the address written in NRF_UICR->BOOTADDR. More...
#include <nrf_mbr.h>
Data Fields | |
uint32_t * | bl_src |
uint32_t | bl_len |
This command copies a new BootLoader. With this command, destination of BootLoader is always the address written in NRF_UICR->BOOTADDR.
Destination is erased by this function. If (destination+bl_len) is in the middle of a flash page, that whole flash page will be erased.
This function will use PROTENSET to protect the flash that is not intended to be written.
On Success, this function will not return. It will start the new BootLoader from reset-vector as normal.
NRF_ERROR_INVALID_STATE | indicates that something was wrong. |
NRF_ERROR_INTERNAL | indicates an internal error that should not happen. |
NRF_ERROR_FORBIDDEN | if NRF_UICR->BOOTADDR is not set |
NRF_ERROR_INVALID_LENGTH | is invalid. |
uint32_t sd_mbr_command_copy_bl_t::bl_len |
Number of 32 bit words to copy for BootLoader
uint32_t* sd_mbr_command_copy_bl_t::bl_src |
Pointer to the source of the Bootloader to be be copied.