Arduino Nicla Sense ME

Overview

The Arduino Nicla Sense ME 1 is designed around Nordic Semiconductor’s nrf52832 ARM Cortex-M4F CPU. The board houses 4 low power industrial grade sensors that can measure rotation, acceleration, pressure, humidity, temperature, air quality and CO2 levels.

Arduino Nicla Sense ME

Fig. 77 Arduino Nicla Sense ME (Credit: Arduino)

Hardware

  • nRF52832 ARM Cortex-M4 processor at 64 MHz

  • 512 kB flash memory, 64 kB SRAM

  • Bluetooth Low Energy

  • Micro USB (USB-B)

  • JST 3-pin 1.2 mm pitch battery connector

  • 10 Digital I/O pins

  • 2 Analog input pins

  • 12 PWM pins

  • One reset button

  • RGB LED (I2C)

  • On board sensors:

    • Accelerometer/Gyroscope: Bosch BHI260AP

    • Gas/Pressure/Temperature/Humidity: Bosch BME688

    • Geomagnetic: Bosch BMM150

    • Digital Pressure: Bosch BMP390

Supported Features

Interface

Controller

Driver/Component

ADC

on-chip

adc

CLOCK

on-chip

clock_control

FLASH

on-chip

flash

GPIO

on-chip

gpio

I2C(M/S)

on-chip

i2c

MPU

on-chip

arch/arm

NVIC

on-chip

arch/arm

PWM

on-chip

pwm

RADIO

on-chip

Bluetooth Low Energy

RTC

on-chip

system clock

SPI(M/S)

on-chip

spi

UART

on-chip

serial

WDT

on-chip

watchdog

Connections and IOs

Available pins:

Arduino Nicla Sense ME pinout

Fig. 78 Arduino Nicla Sense ME pinout (Credit: Arduino)

For more details please refer to the datasheet 2, full pinout 3 and the schematics 4.

Programming and Debugging

Applications for the arduino_nicla_sense_me board configuration can be built and flashed in the usual way (see Building an Application and Run an Application for more details).

Flashing

First, connect the Arduino Nicla Sense ME board to your host computer using the USB port to prepare it for flashing. Then build and flash your application.

Here is an example for the Hello World application.

# From the root of the zephyr repository
west build -b arduino_nicla_sense_me samples/hello_world
west flash

Run a serial host program to connect with your board:

$ minicom -D /dev/ttyACM0

You should see the following message on the console:

Hello World! arduino_nicla_sense_me

Debugging

You can debug an application in the usual way. Here is an example for the Hello World application.

# From the root of the zephyr repository
west build -b arduino_nicla_sense_me samples/hello_world
west debug

References

1

https://docs.arduino.cc/hardware/nicla-sense-me

2

https://docs.arduino.cc/resources/datasheets/ABX00050-datasheet.pdf

3

https://docs.arduino.cc/static/5eff7076d9a031ce823972d6f1faac4a/ABX00050-full-pinout.pdf

4

https://docs.arduino.cc/static/aa5abe05aeec6f8b5fe6f3f605a986b5/ABX00050-schematics.pdf