ST Nucleo WB09KE

Overview

The Nucleo WB09KE board is a Bluetooth® Low Energy wireless and ultra-low-power board featuring an ARM Cortex®-M0+ based STM32WB09KEV MCU, embedding a powerful and ultra-low-power radio compliant with the Bluetooth® Low Energy SIG specification v5.4.

Nucleo WB09KE

More information about the board can be found on the Nucleo WB09KE webpage.

Hardware

Nucleo WB09KE provides the following hardware components:

  • STM32WB09KEV in VFQFPN32 package

  • ARM® 32-bit Cortex®-M0+ CPU

  • 64 MHz maximal CPU frequebct

  • 512 KB Flash

  • 64 KB SRAM

More information about STM32WB09KEV can be found here:

Supported Features

The Zephyr nucleo_wb09ke board target supports the following hardware features:

Interface

Controller

Driver/Component

NVIC

on-chip

nested vector interrupt controller

UART

on-chip

serial port-polling; serial port-interrupt

PINMUX

on-chip

pinmux

GPIO

on-chip

gpio

FLASH

on-chip

internal flash memory

Other hardware features are not yet supported on this Zephyr port.

The default configuration can be found in the defconfig file: boards/st/nucleo_wb09ke/nucleo_wb09ke_defconfig

Connections and IOs

Default Zephyr Peripheral Mapping:

  • USART1 TX/RX : PA1/PB0 (ST-Link Virtual COM Port)

  • BUTTON (B1) : PA0

  • BUTTON (B2) : PB5

  • BUTTON (B3) : PB14

  • LED (LD1/BLUE) : PB1

  • LED (LD2/GREEN) : PB4

  • LED (LD3/RED) : PB2

For more details, please refer to the Nucleo WB09KE board User Manual.

Programming and Debugging

Nucleo WB09KE board includes an ST-LINK-V3EC embedded debug tool interface.

Applications for the nucleo_w09ke board target can be built and flashed in the usual way (see Building an Application and Run an Application for more details).

Flashing

The board is configured to be flashed using the west STM32CubeProgrammer runner, so it must be installed beforehand.

Alternatively, OpenOCD can also be used to flash the board using the --runner (or -r) option:

$ west flash --runner openocd

Flashing an application to Nucleo WB09KE

Connect the Nucleo WB09KE to your host computer using the USB port, then run a serial host program to connect with your Nucleo board:

$ minicom -D /dev/ttyACM0

Now build and flash an application. Here is an example for Hello World.

# From the root of the zephyr repository
west build -b nucleo_wb09ke samples/hello_world
west flash

You should see the following message on the console:

Hello World! nucleo_wb09ke/stm32wb09

Debugging

You can debug an application in the usual way. Here is an example for the Hello World application.

# From the root of the zephyr repository
west build -b nucleo_wb09ke samples/hello_world
west debug