Working with nRF54L Series

Note

All software for the nRF54L15 SoC is experimental and hardware availability is restricted to the participants in the limited sampling program.

Zephyr and the nRF Connect SDK provide support and contain board definitions for developing on the following nRF54L Series device:

DK	PCA number	Board target	Documentation
nRF54L15 PDK	PCA10156	nrf54l15pdk@0.2.1/nrf54l15/cpuapp for the PDK revision v0.2.1, AB0-ES7 (Engineering A). nrf54l15pdk/nrf54l15/cpuapp for the PDK revisions v0.3.0 and v0.7.0 (Engineering A).	–

Note

The v0.2.1 revision of the nRF54L15 PDK has Button 3 and Button 4 connected to GPIO port 2 that do not support interrupts. The workaround for this issue is enabled by default with the CONFIG_DK_LIBRARY_BUTTON_NO_ISR Kconfig option, but it increases the overall power consumption of the system.

Subpages:

• Features of the nRF54L15 PDK
  • Supported protocols
  • MCUboot bootloader support
• Getting started with nRF54L15 PDK
  • Minimum requirements
  • Downloading the code
  • Testing with the Blinky sample
  • Additional software
  • Programming the Hello World! sample
  • Reading the logs
  • Next steps
• Testing the DFU solution