nRF54L15 PDK
Overview
Note
All software for the nRF54L15 SoC is experimental and hardware availability is restricted to the participants in the limited sampling program.
The nRF54L15 Preview Development Kit hardware provides support for the Nordic Semiconductor nRF54L15 Arm Cortex-M33 CPU and the following devices:
SAADC
CLOCK
RRAM
GPIO
TWIM
MPU
NVIC
PWM
GRTC
Segger RTT (RTT Console)
SPI
UARTE
WDT
nRF54L15 PDK (Credit: Nordic Semiconductor)
Hardware
nRF54L15 PDK has two crystal oscillators:
High-frequency 32 MHz crystal oscillator (HFXO)
Low-frequency 32.768 kHz crystal oscillator (LFXO)
The crystal oscillators can be configured to use either internal or external capacitors.
Supported Features
The nrf54l15pdk/nrf54l15/cpuapp board configuration supports the following
hardware features:
Interface |
Controller |
Driver/Component |
|---|---|---|
SAADC |
on-chip |
adc |
CLOCK |
on-chip |
clock_control |
RRAM |
on-chip |
flash |
GPIO |
on-chip |
gpio |
TWIM |
on-chip |
i2c |
MPU |
on-chip |
arch/arm |
NVIC |
on-chip |
arch/arm |
PWM |
on-chip |
pwm |
GRTC |
on-chip |
counter |
RTT |
Segger |
console |
SPI(M/S) |
on-chip |
spi |
SPU |
on-chip |
system protection |
UARTE |
on-chip |
serial |
WDT |
on-chip |
watchdog |
Other hardware features have not been enabled yet for this board.
Programming and Debugging
Applications for the nrf54l15pdk/nrf54l15/cpuapp board can be
built, flashed, and debugged in the usual way. See
Building an Application and Run an Application for more details on
building and running.
Flashing
As an example, this section shows how to build and flash the Hello World application.
Warning
When programming the device, you might get an error similar to the following message:
ERROR: The operation attempted is unavailable due to readback protection in
ERROR: your device. Please use --recover to unlock the device.
This error occurs when readback protection is enabled. To disable the readback protection, you must recover your device.
Enter the following command to recover the core:
west flash --recover
The --recover command erases the flash memory and then writes a small binary into
the recovered flash memory.
This binary prevents the readback protection from enabling itself again after a pin
reset or power cycle.
Follow the instructions in the Nordic nRF5x Segger J-Link page to install and configure all the necessary software. Further information can be found in Flashing.
To build and program the sample to the nRF54L15 PDK, complete the following steps:
First, connect the nRF54L15 PDK to you computer using the IMCU USB port on the PDK. Next, build the sample by running the following command:
# From the root of the zephyr repository
west build -b nrf54l15pdk/nrf54l15/cpuapp samples/hello_world
west flash