nRF5x System Off demo¶
Overview¶
This sample can be used for basic power measurement and as an example of deep sleep on Nordic platforms. The functional behavior is:
Busy-wait for 2 seconds
Sleep for 2 seconds without device power control
Sleep for 2 seconds after turning UART off, which reduces current draw by a couple hundred uA
Turn the system off after enabling wakeup through a button press
A power monitor will be able to distinguish among these states.
This sample also demonstrates the use of a SYS_INIT() call to
disable the deep sleep functionality before the kernel starts, which
prevents the board from powering down during initialization of drivers
that use unbounded delays to wait for startup.
Requirements¶
This application uses nRF51 DK or nRF52 DK board for the demo.
Building, Flashing and Running¶
west build -b nrf52dk_nrf52832 samples/boards/nrf52/system_off
west flash
Running:
Open UART terminal.
Power Cycle Device.
Device will demonstrate two activity levels which can be measured.
Device will demonstrate long sleep at minimal non-off power.
Device will turn itself off using deep sleep state 1. Press Button 1 to wake the device and restart the application as if it had been powered back on.