maxim,max17055 (on i2c bus)

Vendor: Maxim Integrated Products

Description

Maxim MAX17055 Fuel Gauge

Properties

Properties not inherited from the base binding file.

Name

Type

Details

design-voltage

int

 
Battery Design Voltage in mV (3300 to 4400)

This property is required.

desired-voltage

int

 
Battery Desired Voltage in mV (3300 to 4400)

This property is required.

desired-charging-current

int

 
Battery Design Charging Current in mA (e.g. 2000)

This property is required.

rsense-mohms

int

 
Value of Rsense resistor in milliohms (e.g. 5). It cannot be 0.

This property is required.

supply-gpios

phandle-array

 
GPIO specifier that controls power to the device.

This property should be provided when the device has a dedicated
switch that controls power to the device.  The supply state is
entirely the responsibility of the device driver.

Contrast with vin-supply.

vin-supply

phandle

 
Reference to the regulator that controls power to the device.
The referenced devicetree node must have a regulator compatible.

This property should be provided when device power is supplied
by a shared regulator.  The supply state is dependent on the
request status of all devices fed by the regulator.

Contrast with supply-gpios.  If both properties are provided
then the regulator must be requested before the supply GPIOS is
set to an active state, and the supply GPIOS must be set to an
inactive state before releasing the regulator.