STM32 PM Blinky


This sample is a minimum application to demonstrate basic power management behavior in a basic blinking LED set up using the GPIO API in low power context.


The board should support enabling PM. For a STM32 based target, it means that it should support a clock source alternative to Cortex Systick that can be used in core sleep states, as LPTIM (st,stm32-lptim).

Building and Running

Build and flash Blinky as follows, changing stm32l562e_dk for your board:

west build -b stm32l562e_dk samples/basic/blinky
west flash

After flashing, the LED starts to blink.

PM configurations

By default, CONFIG_PM_DEVICE and CONFIG_PM_DEVICE_RUNTIME are enabled, but user can also deactivate one or the other to see each configuration in play.