ti-cc13xx-cc26xx-gpio.h File Reference

Go to the source code of this file.

Macros
#define	CC13XX_CC26XX_GPIO_DEBOUNCE   (1U << 8)
	Enable GPIO pin debounce.
GPIO drive strength flags
The drive strength flags are a Zephyr specific extension of the standard GPIO flags specified by the Linux GPIO binding. Only applicable for Texas Instruments CC13xx/CC26xx SoCs. The interface supports two different drive strengths: DFLT - The lowest drive strength supported by the HW ALT - The highest drive strength supported by the HW
#define	CC13XX_CC26XX_GPIO_DS_DFLT   (0x0U << CC13XX_CC26XX_GPIO_DS_POS)
	Default drive strength.
#define	CC13XX_CC26XX_GPIO_DS_ALT   (0x3U << CC13XX_CC26XX_GPIO_DS_POS)
	Alternative drive strength.

Macro Definition Documentation

CC13XX_CC26XX_GPIO_DEBOUNCE

#define CC13XX_CC26XX_GPIO_DEBOUNCE   (1U << 8)

Enable GPIO pin debounce.

The debounce flag is a Zephyr specific extension of the standard GPIO flags specified by the Linux GPIO binding. Only applicable for Texas Instruments CC1xx/CC26xx SoCs.

CC13XX_CC26XX_GPIO_DS_ALT

#define CC13XX_CC26XX_GPIO_DS_ALT   (0x3U << CC13XX_CC26XX_GPIO_DS_POS)

Alternative drive strength.

CC13XX_CC26XX_GPIO_DS_DFLT

#define CC13XX_CC26XX_GPIO_DS_DFLT   (0x0U << CC13XX_CC26XX_GPIO_DS_POS)

Default drive strength.