Selector module

The selector module is used to send selector_event that informs about the current selector state. The module has one implementation, which uses hardware selectors (selector_hw.c).

Module events

Source Module	Input Event	This Module	Output Event	Sink Module
Source modules for module_state_event	module_state_event	selector
Power manager module	power_down_event
Bluetooth LE advertising module	wake_up_event
Buttons module
HID forward module
Motion module
Power manager module
Wheel module
			module_state_event	Sink modules for module_state_event
			selector_event	Bluetooth LE bond module

Note

See the Application overview for more information about the event-based communication in the nRF Desktop application and about how to read this table.

Configuration

The module implemented in selector_hw.c uses the Zephyr General-Purpose Input/Output (GPIO) driver to check the state of hardware selectors. For this reason, you should set CONFIG_GPIO option.

Set CONFIG_DESKTOP_SELECTOR_HW_ENABLE option to enable the module. The configuration for this module is an array of selector_config pointers. The array is written in the selector_hw_def.h file located in the board-specific directory in the application configuration directory.

For every hardware selector, define the following parameters:

• selector_config.id - ID of the hardware selector.

• selector_config.pins - Pointer to the array of gpio_pin.

• selector_config.pins_size - Size of the array of gpio_pin.

Note

Each source of selector_event must have a unique ID to properly distinguish events from different sources.

Implementation details

The selector_event that the module sends to inform about the current hardware selector state is sent on the following occasions:

• System start or wakeup (for every defined selector).

• Selector state change when the application is running (only for the selector that changed state).

When the application goes to sleep, selectors are not informing about the state change (interrupts are disabled).

If a selector is placed between states, it is in unknown state and selector_event is not sent.

Recording of selector state changes is implemented using GPIO callbacks (gpio_callback) and work (k_work_delayable). Each state change triggers an interrupt (GPIO interrupt for pin level high). Callback of an interrupt submits work, which sends selector_event.