Constant latency hotfix module

Enable the constant latency hotfix module to use a device configuration with constant latency interrupts. This reduces the interrupt propagation time, but increases the power consumption.

Module events

Source Module	Input Event	This Module	Output Event	Sink Module
Power manager module	power_down_event	constlat
Source modules for module_state_event	module_state_event
Bluetooth LE advertising module	wake_up_event
Buttons module
HID forward module
Motion module
Power manager module
Wheel module

Note

See the Overview: Firmware architecture for more information about the event-based communication in the nRF Desktop application and about how to read this table.

Configuration

Enable the module with the CONFIG_DESKTOP_CONSTLAT_ENABLE option.

You can set the CONFIG_DESKTOP_CONSTLAT_DISABLE_ON_STANDBY to disable the constant latency interrupts when the device goes to the low power mode (on power_down_event). The constant latency interrupts are reenabled on wake_up_event.