Wi-Fi: Station

The Station sample demonstrates how to connect the Wi-Fi station to a specified access point using Dynamic Host Configuration Protocol (DHCP).

Requirements

The sample supports the following development kit:

Hardware platforms

PCA

Board name

Build target

nRF7002 DK

PCA10143

nrf7002dk_nrf5340

nrf7002dk_nrf5340_cpuapp

Overview

This sample can perform Wi-Fi operations such as connect and disconnect in the 2.4GHz and 5GHz bands depending on the capabilities of an access point.

Using this sample, the development kit can connect to the specified access point in STA mode.

Building and running

This sample can be found under samples/wifi/sta in the nRF Connect SDK folder structure.

When built as a non-secure firmware image for the _ns build target, the sample automatically includes the Trusted Firmware-M (TF-M).

To build the sample with Visual Studio Code, follow the steps listed on the Building nRF Connect SDK application quick guide page in the nRF Connect for VS Code extension documentation. See Building and programming an application for other building and programming scenarios and Testing and debugging an application for general information about testing and debugging in the nRF Connect SDK.

Currently, the following board(s) are supported:

  • nRF7002 DK

You must configure the following Wi-Fi credentials in prj.conf:

  • Network name (SSID)

  • Key management

  • Password

Note

You can also use menuconfig to enable Key management option.

See Interactive Kconfig interfaces in the Zephyr documentation for instructions on how to run menuconfig.

To build for the nRF7002 DK, use the nrf7002dk_nrf5340_cpuapp build target. The following is an example of the CLI command:

west build -b nrf7002dk_nrf5340_cpuapp

Testing

After programming the sample to your development kit, complete the following steps to test it:

  1. Connect the kit to the computer using a USB cable. The kit is assigned a COM port (Windows) or ttyACM device (Linux), which is visible in the Device Manager.

  2. Connect to the kit with a terminal emulator (for example, PuTTY). See How to connect with PuTTY for the required settings.

    The sample shows the following output:

    <inf> sta: Connection requested
<inf> sta: Connected
Status: successful
==================
  State: COMPLETED
  Interface Mode: STATION
  Link Mode: WIFI 6 (802.11ax/HE)
  SSID: NORDIC-GUEST
  BSSID: F0:1D:2D:72:EB:EF
  Band: 5GHz
  Channel: 116
  Security: WPA2-PSK
  MFP: Optional
  RSSI: -55
<inf> sta: IP address: 192.168.48.41
<inf> sta: Disconnect requested
<inf> sta: Disconnection request done (0)
Status: successful
==================
  State: DISCONNECTED

Dependencies

This sample uses the following sdk-nrfxlib library: