wpanusb sample

Overview

This application exports ieee802154 radio over USB to be used in other OSes such as Linux. For Linux, the ieee802154 stack would be implemented using the Linux SoftMAC driver. This sample can be found under samples/net/wpanusb in the Zephyr project tree.

Requirements

  • a Zephyr board with supported 802.15.4 radio and supported USB driver (such as the nRF52840 DK or SAM R21 Xplained Pro Evaluation Kit) connected via USB to a Linux host

  • wpanusb Linux kernel driver (in the process of being open sourced)

  • wpan-tools (available for all Linux distributions)

Building and Running

There are configuration files for various setups in the samples/net/wpanusb directory:

  • prj.conf

    This is the standard default config. This can be used by itself for hardware which has native 802.15.4 support.

  • overlay-cc2520.conf

    This overlay config enables support for CC2520

Build the wpanusb sample for a board:

west build -b <board to use> samples/net/wpanusb -- -DOVERLAY_CONFIG=<overlay file to use>

Example building for the Nordic nRF52840 Development Kit:

west build -b nrf52840dk_nrf52840 samples/net/wpanusb

When connected to Linux with wpanusb kernel driver, it is recognized as:

...
T:  Bus=01 Lev=02 Prnt=02 Port=00 Cnt=01 Dev#=  3 Spd=12  MxCh= 0
D:  Ver= 1.10 Cls=ff(vend.) Sub=00 Prot=00 MxPS=64 #Cfgs=  1
P:  Vendor=2fe3 ProdID=000d Rev=01.00
C:  #Ifs= 1 Cfg#= 1 Atr=c0 MxPwr=100mA
I:  If#= 0 Alt= 0 #EPs= 1 Cls=ff(vend.) Sub=00 Prot=00 Driver=wpanusb
...

The following script enables the network interface in Linux (uses iwpan tool from above):

#!/bin/sh
PHY=`iwpan phy | grep wpan_phy | cut -d' ' -f2`
echo 'Using phy' $PHY
iwpan dev wpan0 set pan_id 0xabcd
iwpan dev wpan0 set short_addr 0xbeef
iwpan phy $PHY set channel 0 26
ip link add link wpan0 name lowpan0 type lowpan
ip link set wpan0 up
ip link set lowpan0 up