atmel,sam0-uart¶

Description¶

These nodes are “uart” bus nodes.

Atmel SAM0 SERCOM UART driver

Properties¶

Properties not inherited from the base binding file.

Name	Type	Details
`rxpo`	`int`	Receive Data Pinout This property is required.
`txpo`	`int`	Transmit Data Pinout This property is required.
`collision-detection`	`boolean`	Enable collision detection for half-duplex mode.
`clock-frequency`	`int`	Clock frequency information for UART operation
`current-speed`	`int`	Initial baud rate setting for UART
`hw-flow-control`	`boolean`	Set to enable RTS/CTS flow control at boot time

Properties inherited from the base binding file, which defines common properties that may be set on many nodes. Not all of these may apply to the “atmel,sam0-uart” compatible.

Name	Type	Details
`reg`	`array`	register space This property is required. See Important properties for more information.
`interrupts`	`array`	interrupts for device This property is required. See Important properties for more information.
`clocks`	`phandle-array`	Clock gate information This property is required.
`clock-names`	`string-array`	name of each clock This property is required.
`dmas`	`phandle-array`	Optional TX & RX dma specifiers. Each specifier will have a phandle reference to the dmac controller, the channel number, and peripheral trigger source. For example dmas for TX, RX on SERCOM3 dmas = <&dmac 0 0xb>, <&dmac 0 0xa>;
`dma-names`	`string-array`	Required if the dmas property exists. This should be "tx" and "rx" to match the dmas property. For example dma-names = "tx", "rx";
`label`	`string`	Human readable string describing the device (used as device_get_binding() argument) This property is required. See Important properties for more information.
`status`	`string`	indicates the operational status of a device Legal values: `'ok'`, `'okay'`, `'disabled'`, `'reserved'`, `'fail'`, `'fail-sss'` See Important properties for more information.
`compatible`	`string-array`	compatible strings This property is required. See Important properties for more information.
`reg-names`	`string-array`	name of each register space
`interrupts-extended`	`compound`	extended interrupt specifier for device
`interrupt-names`	`string-array`	name of each interrupt
`interrupt-parent`	`phandle`	phandle to interrupt controller node
`#address-cells`	`int`	number of address cells in reg property
`#size-cells`	`int`	number of size cells in reg property
`io-channels`	`phandle-array`	IO channels specifiers
`io-channel-names`	`string-array`	Provided names of IO channel specifiers