st,stm32-fdcan

Vendor: STMicroelectronics

Description

These nodes are “can” bus nodes.

Bosch m_can CAN-FD controller

Properties

Properties not inherited from the base binding file.

Name

Type

Details

pinctrl-0

phandles

 
GPIO pin configuration for CAN signals (RX, TX). We expect
that the phandles will reference pinctrl nodes.

For example the can1 would be
   pinctrl-0 = <&fdcan1_rx_pa11 &fdcan1_tx_pa12>;

bus-speed-data

int

 
data phase bus speed in Baud/s

This property is required.

sjw-data

int

 
Resynchronization jump width for the data phase. (ISO11898-1:2015)

This property is required.

prop-seg-data

int

 
Time quantums of propagation segment for the data phase. (ISO11898-1:2015)

phase-seg1-data

int

 
Time quantums of phase buffer 1 segment for the data phase. (ISO11898-1:2015)

phase-seg2-data

int

 
Time quantums of phase buffer 2 segment for the data phase. (ISO11898-1:2015)

sample-point-data

int

 
Sample point in permille for the data phase. This param is required if segments are not given. If the sample point is given, the segments are ignored.

tx-delay-comp-offset

int

bus-speed

int

 
bus speed in Baud/s

This property is required.

sjw

int

 
Resynchronization jump width (ISO 11898-1)

This property is required.

prop-seg

int

 
Time quantums of propagation segment (ISO 11898-1)

phase-seg1

int

 
Time quantums of phase buffer 1 segment (ISO 11898-1)

phase-seg2

int

 
Time quantums of phase buffer 2 segment (ISO 11898-1)

sample-point

int

 
Sample point in permille. This param is required if segments are not given. If the sample point is given, the segments are ignored.