CONFIG_USB_DC_STM32_DISCONN_ENABLE

(No prompt – not directly user assignable.)

Type: bool

Help

Say Y if your board uses USB DISCONNECT pin to enable the
pull-up resistor on USB DP.

Direct dependencies

USB_DC_STM32 && USB

(Includes any dependencies from ifs and menus.)

Defaults

No defaults. Implicitly defaults to n.

Symbols that select this symbol

Kconfig definition

At <Zephyr>/drivers/usb/device/Kconfig:105

Included via <Zephyr>/Kconfig:8<Zephyr>/Kconfig.zephyr:32<Zephyr>/drivers/Kconfig:68<Zephyr>/drivers/usb/Kconfig:11

Menu path: (Top) → Device Drivers → USB

config USB_DC_STM32_DISCONN_ENABLE
    bool
    depends on USB_DC_STM32 && USB
    help
      Say Y if your board uses USB DISCONNECT pin to enable the
      pull-up resistor on USB DP.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)