Help¶

Controls if front-end module (FEM) is to be configured and enabled
when MPSL is initialized. Default type of FEM to use depends on which
compatible nodes are in devicetree.

Direct dependencies¶

!(SOC_NRF5340_CPUAPP || SOC_NRF5340_CPUNET) && (MPSL_FEM_NRF21540_GPIO_SUPPORT || MPSL_FEM_GENERIC_TWO_CTRL_PINS_SUPPORT)

(Includes any dependencies from ifs and menus.)

Default¶

y

Kconfig definition¶

At <nRF>/subsys/mpsl/Kconfig.fem:18

Included via <Zephyr>/Kconfig:8 → <Zephyr>/Kconfig.zephyr:23 → <Zephyr>/modules/Kconfig:6 → <BuildDir>/kconfig/Kconfig.modules:2 → <nRF>/Kconfig.nrf:50 → <nRF>/subsys/Kconfig:34 → <nRF>/subsys/mpsl/Kconfig:36

Menu path: (Top) → Modules → nrf (/home/runner/work/sdk-nrf/sdk-nrf/ncs/nrf) → Nordic nRF Connect → Nordic MPSL

config MPSL_FEM
    bool "Radio front-end module (FEM) support"
    default y
    depends on !(SOC_NRF5340_CPUAPP || SOC_NRF5340_CPUNET) && (MPSL_FEM_NRF21540_GPIO_SUPPORT || MPSL_FEM_GENERIC_TWO_CTRL_PINS_SUPPORT)
    help
      Controls if front-end module (FEM) is to be configured and enabled
      when MPSL is initialized. Default type of FEM to use depends on which
      compatible nodes are in devicetree.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)