Help¶

This sets the APB1 prescaler which changes the frequency of APB1_CLK.
APB1_CLK frequency = OSC_CLK / APB1_PRE. The APB1 prescaler allowed
value is from 1 to 10.

The generated frequency of APB1_CLK should comply with the following
requirements:
- The frequency of APB1_CLK must be set to:
4MHz <= APB1_CLK <= 50MHz.
- The frequency of APB1_CLK must be an integer division (including 1)
of the frequency of the Core clock.

Direct dependencies¶

SOC_FAMILY_NPCX && CLOCK_CONTROL

(Includes any dependencies from ifs and menus.)

Default¶

4

Kconfig definition¶

At <Zephyr>/drivers/clock_control/Kconfig.npcx:21

Included via <Zephyr>/Kconfig:8 → <Zephyr>/Kconfig.zephyr:32 → <Zephyr>/drivers/Kconfig:54 → <Zephyr>/drivers/clock_control/Kconfig:43

Menu path: (Top) → Device Drivers → Hardware clock controller support

config CLOCK_NPCX_APB1_PRESCALER
    int "APB1 prescaler"
    range 1 10
    default 4
    depends on SOC_FAMILY_NPCX && CLOCK_CONTROL
    help
      This sets the APB1 prescaler which changes the frequency of APB1_CLK.
      APB1_CLK frequency = OSC_CLK / APB1_PRE. The APB1 prescaler allowed
      value is from 1 to 10.

      The generated frequency of APB1_CLK should comply with the following
      requirements:
      - The frequency of APB1_CLK must be set to:
      4MHz <= APB1_CLK <= 50MHz.
      - The frequency of APB1_CLK must be an integer division (including 1)
      of the frequency of the Core clock.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)