Enhanced Serial Peripheral Interface
This sample demonstrates how to use the Enhanced Serial Peripheral Interface (eSPI) API. It shows how to configure and select eSPI controller capabilities as part of a simple eSPI handshake that includes exchanging virtual wire packets.
Standard platform signals are sent virtual wire packets over the bus. Callbacks are registered that will write to the console indicating main eSPI events and when a virtual wire is received.
Building and Running
The sample can be built and executed on boards supporting eSPI. Any pins required for minimum eSPI handshake should be configured. Sample requires a correct harness and fixture setup. Please connect an eSPI device to the testing board. After that for the correct execution of that sample in twister, add into boards’s map-file next fixture settings:
- fixture: espi_device_connect
Hello eSPI test! eSPI test - I/O initialization...complete eSPI slave configured successfully! eSPI test - callbacks initialization... complete eSPI test - callbacks registration... complete eSPI test - Power initialization...complete eSPI test - Handshake eSPI BUS reset 0 VW channel is ready PLT_RST changed 1 1st phase completed 2nd phase completed 3rd phase completed
note:: The values shown above might differ.