ite,it82xx2-usb

Vendor: ITE Tech. Inc.

Description

These nodes are “usb” bus nodes.

ITE IT82XX2 USB in device mode

Properties

Properties not inherited from the base binding file.

Name

Type

Details

pinctrl-0

phandles

Pin configuration/s for the first state. Content is specific to the
selected pin controller driver implementation.

This property is required.

pinctrl-names

string-array

Names for the provided states. The number of names needs to match the
number of states.

This property is required.

wucctrl

phandles

usbd node WUC interrupt.

pinctrl-1

phandles

Pin configuration/s for the second state. See pinctrl-0.

pinctrl-2

phandles

Pin configuration/s for the third state. See pinctrl-0.

pinctrl-3

phandles

Pin configuration/s for the fourth state. See pinctrl-0.

pinctrl-4

phandles

Pin configuration/s for the fifth state. See pinctrl-0.

num-bidir-endpoints

int

Number of bi-directional endpoints supported by hardware
(including EP0)

This property is required.

num-in-endpoints

int

Number of IN endpoints supported by hardware
(including EP0 IN)

num-out-endpoints

int

Number of OUT endpoints supported by hardware
(including EP0 OUT)

maximum-speed

string

Configures USB controllers to work up to a specific speed. Valid arguments are "super-speed", "high-speed", "full-speed" and "low-speed". If this is not passed via DT, USB controllers should use their maximum hardware capability.

Legal values: 'low-speed', 'full-speed', 'high-speed', 'super-speed'

vbus-gpios

phandle-array

Control VBUS via GPIO pin.