nordic,npm6001 (on i2c bus)

Vendor: Nordic Semiconductor

Description

Nordic nPM6001

Properties

Properties not inherited from the base binding file.

Name

Type

Details

nordic,ready-high-drive

boolean

Set drive strength to high for READY pin.

nordic,nint-high-drive

boolean

Set drive strength to high for NINT pin.

nordic,sda-high-drive

boolean

Set drive strength to high for SDA pin.

nordic,buck-mode0-input-type

string

Input type for BUCK_MODE0 pin. Defaults IC boot-time value.

Default value: schmitt

Legal values: 'schmitt', 'cmos'

nordic,buck-mode0-pull-down

boolean

Enable pull-down resistor for BUCK_MODE0 pin.

nordic,buck-mode1-input-type

string

Input type for BUCK_MODE1 pin. Defaults IC boot-time value.

Default value: schmitt

Legal values: 'schmitt', 'cmos'

nordic,buck-mode1-pull-down

boolean

Enable pull-down resistor for BUCK_MODE1 pin.

nordic,buck-mode2-input-type

string

Input type for BUCK_MODE2 pin. Defaults IC boot-time value.

Default value: schmitt

Legal values: 'schmitt', 'cmos'

nordic,buck-mode2-pull-down

boolean

Enable pull-down resistor for BUCK_MODE2 pin.

supply-gpios

phandle-array

GPIO specifier that controls power to the device.

This property should be provided when the device has a dedicated
switch that controls power to the device.  The supply state is
entirely the responsibility of the device driver.

Contrast with vin-supply.

vin-supply

phandle

Reference to the regulator that controls power to the device.
The referenced devicetree node must have a regulator compatible.

This property should be provided when device power is supplied
by a shared regulator.  The supply state is dependent on the
request status of all devices fed by the regulator.

Contrast with supply-gpios.  If both properties are provided
then the regulator must be requested before the supply GPIOS is
set to an active state, and the supply GPIOS must be set to an
inactive state before releasing the regulator.