espressif,esp32-twai

Vendor: Espressif Systems

Description

Espressif ESP32 Two-Wire Automotive Interface (TWAI)

Properties

Top level properties

These property descriptions apply to “espressif,esp32-twai” nodes themselves. This page also describes child node properties in the following sections.

Properties not inherited from the base binding file.

Name

Type

Details

pinctrl-0

phandles

Pin configuration/s for the first state. Content is specific to the
selected pin controller driver implementation.

This property is required.

pinctrl-names

string-array

Names for the provided states. The number of names needs to match the
number of states.

This property is required.

clkout-divider

int

Clock divider for the CLKOUT signal. If not set, the CLKOUT signal is turned off.

Valid values are 1 or any even number from 2 to 14 for ESP32 and 2 to 490 for newer
Espressif MCUs like ESP32-C3.

bus-speed

int

Initial bitrate in bit/s.

This property is required.

sample-point

int

Initial sample point in per mille (e.g. 875 equals 87.5%).

This property is required.

phys

phandle

Actively controlled CAN transceiver.

Example:
  transceiver0: can-phy0 {
    compatible = "nxp,tja1040", "can-transceiver-gpio";
    standby-gpios = <gpioa 0 GPIO_ACTIVE_HIGH>;
    max-bitrate = <1000000>;
    #phy-cells = <0>;
  };

  &can0 {
    status = "okay";

    phys = <&transceiver0>;
  };

pinctrl-1

phandles

Pin configuration/s for the second state. See pinctrl-0.

pinctrl-2

phandles

Pin configuration/s for the third state. See pinctrl-0.

pinctrl-3

phandles

Pin configuration/s for the fourth state. See pinctrl-0.

pinctrl-4

phandles

Pin configuration/s for the fifth state. See pinctrl-0.

Child node properties

Name

Type

Details

max-bitrate

int

The maximum bitrate supported by the CAN transceiver in bits/s.

This property is required.