GigaDevice GD32E507Z-EVAL

Overview

The GD32E507Z-EVAL board is a hardware platform that enables prototyping on GD32E507ZE Cortex-M33 High Performance MCU.

The GD32E507ZE features a single-core ARM Cortex-M33 MCU which can run up to 180 MHz with flash accesses zero wait states, 512kiB of Flash, 128kiB of SRAM and 112 GPIOs.

gd32e507z_eval

Hardware

  • GD32E507ZET6 MCU

  • AT24C02C 2Kb EEPROM

  • GD25Q16 16Mbit SPI and QSPI NOR Flash

  • GD9FU1G8F2A 1Gbit NAND Flash

  • Micron MT48LC16M16A2P-6AIT 256Mbit SDRAM

  • 4 x User LEDs

  • 1 x Joystick (L/R/U/D/C)

  • 1 x USART (connected to USB VCOM at J1 connector)

  • 1 x POT connected to an ADC input

  • Headphone interface

  • USB FS connector

  • 1 x CAN (includes SN65HVD230 PHY)

  • Ethernet Interface

  • 3.2” RGB-LCD (320x240)

  • GD-Link on board programmer

  • J-Link/JTAG connector

For more information about the GD32E507 SoC and GD32E507Z-EVAL board:

Supported Features

The board configuration supports the following hardware features:

Peripheral

Kconfig option

Devicetree compatible

EXTI

CONFIG_GD32_EXTI

gd,gd32-exti

GPIO

CONFIG_GPIO

gd,gd32-gpio

NVIC

N/A

arm,v8m-nvic

PWM

CONFIG_PWM

gd,gd32-pwm

SYSTICK

N/A

N/A

USART

CONFIG_SERIAL

gd,gd32-usart

Serial Port

The GD32E507Z-EVAL board has one serial communication port. The default port is USART0 with TX connected at PA9 and RX at PA10. USART0 is exposed as a virtual COM port via the J1 USB connector.

Programming and Debugging

Before programming your board make sure to configure boot jumpers as follows:

  • JP3/4: Select 2-3 for both (boot from user memory)