Seagate FireCuda Gaming SSD (FaZe) board

Overview

The FaZe board can be found in the Seagate FireCuda Gaming SSD devices. A NVMe SSD and two chips are embedded: an ASMedia ASM2364 USB-to-PCIe bridge controller and a NXP LPC11U67 MCU. The former is handling the USB type-C to SSD I/Os while the latter is dedicated to the LED effects. The two chips are connected together through I2C and GPIOs.

This Zephyr port is running on the NXP LPC11U67 MCU.

Seagate FireCuda Gaming SSD

Hardware

  • NXP LPC11U67 MCU (LQFP48 package):

    • ARM Cortex-M0+

    • 20 KB SRAM: 16 KB (SRAM0) + 2 KB (SRAM1) + 2KB (USB SRAM)

    • 128 KB on-chip flash

    • 4 KB on-chip EEPROM

  • External devices connected to the NXP LPC11U67 MCU:

    • ASMedia ASM2364 USB-to-PCIe bridge (I2C master on port O).

    • 6 RGB LEDs connected to a TI LP5030 LED controller (I2C device on port 1).

    • 1 white LED (SSD activity blinking).

More information can be found here:

Supported Features

All the hardware features available on the FaZe board are supported in Zephyr.

Interface

Controller

Driver/Component

NVIC

on-chip

nested vector interrupt controller

SYSTICK

on-chip

systick

IOCON

on-chip

pinmux

CLOCK

on-chip

clock and reset control

GPIO

on-chip

gpio

I2C

on-chip

i2c master/slave controller

UART

on-chip

serial port-polling; serial port interrupt

EEPROM

on-chip

eeprom

Connections and IOs

The IOCON controller can be used to configure the LPC11U67 pins.

Name

Function

Usage

PIO0_2

GPIO

ASM2364 interrupt

PIO0_4

I2C0

I2C0 SCL

PIO0_5

I2C0

I2C0 SDA

PIO0_7

I2C1

I2C1 SCL

PIO0_18

UART

USART0 RX

PIO0_19

UART

USART0 TX

PIO0_20

GPIO

USB sleep

PIO1_23

GPIO

SSD activity white LED

PIO1_24

I2C1

I2C1 SDA

Programming and Debugging

Flashing

The NXP LPC11U67 MCU can be flashed by connecting an external debug probe to the SWD port (on-board 4-pins J2 header). In the default OpenOCD configuration (boards/arm/faze/support/openocd.cfg) the ST Link interface is selected. You may need to replace it with the interface of your debug probe.

Once the debug probe is connected to both the FaZe board and your host computer then you can simply run the west flash command to write a firmware image you built into flash.

Debugging

Please refer to the Flashing section and run the west debug command instead of west flash.

References