.. _grow_r502a: GROW_R502A Fingerprint Sensor ############################# Overview ******** This sample has the below functionalities: #. Shows the number of fingerprints stored in the sensor. #. When SENSOR_ATTR_RECORD_FREE_IDX is set then it search for free index in sensor library. #. When SENSOR_ATTR_RECORD_ADD is set then it adds a new fingerprint to the sensor. #. When SENSOR_ATTR_RECORD_FIND is set then it tries to find a match for the input fingerprint. On finding a match it returns ID and confidence. #. When SENSOR_ATTR_RECORD_DEL is set then it deletes a fingerprint from the sensor. Note: Fingerprint add & delete functionalities work only when SENSOR_TRIG_TOUCH is set. Tricolored LED in the sensor hardware will, flash on the below conditions: #. On successful addition or deletion of fingerprint it will flash in blue three times. #. On finding a match for the input fingerprint it will flash in purple. #. In all other cases it will flash in red. Wiring ******* This sample uses an external breakout for the sensor. A devicetree overlay must be provided to identify the UART bus and the GPIO used to control the sensor. Sensor can be powered using mentioned optional GPIO. References ********** For more information about the GROW_R502A Fingerprint Sensor see http://en.hzgrow.com/product/143.html Building and Running ******************** After providing a devicetree overlay that specifies the sensor location, build this sample app using: .. zephyr-app-commands:: :zephyr-app: samples/sensor/grow_r502a :board: nrf52840dk_nrf52840 :goals: build flash Sample Output ************* .. code-block:: console *** Booting Zephyr OS build zephyr-v3.1.0-2640-g328bb73113d4 *** template count : 0 Fingerprint Deleted at ID #3 Fingerprint template free idx at ID #0 Waiting for valid finger to enroll as ID #0 Place your finger Fingerprint successfully stored at #0 template count : 1 Matched ID : 0 confidence : 170 template count : 1 Matched ID : 0 confidence : 136 template count : 1 Matched ID : 0 confidence : 318