:orphan: .. raw:: html .. dtcompatible:: renesas,smartbond-lp-osc .. _dtbinding_renesas_smartbond_lp_osc: renesas,smartbond-lp-osc ######################## Vendor: :ref:`Renesas Electronics Corporation ` Description *********** .. code-block:: none Smartbond low power oscillator Properties ********** .. tabs:: .. group-tab:: Node specific properties Properties not inherited from the base binding file. .. list-table:: :widths: 1 1 4 :header-rows: 1 * - Name - Type - Details * - ``calibration-interval`` - ``int`` - .. code-block:: none Time in seconds between calibration of low power clock RCX or RC32K. For XTAL32K this value is not used. If set to 0 calibration will not be performed. This can be applied when XTAL32K is enabled for low power clock and RCX or RC32K is used for watchdog and strict timing is not required. Default value: ``1`` * - ``settle-time`` - ``int`` - .. code-block:: none This is only valid for XTAL32K. Time in ms needed to XTAL32K to settle. Default value: ``8000`` * - ``clock-frequency`` - ``int`` - .. code-block:: none output clock frequency (Hz) This property is **required**. .. group-tab:: Deprecated node specific properties Deprecated properties not inherited from the base binding file. (None) .. group-tab:: Base properties Properties inherited from the base binding file, which defines common properties that may be set on many nodes. Not all of these may apply to the "renesas,smartbond-lp-osc" compatible. (None)