:orphan: .. raw:: html .. dtcompatible:: ambiq,bt-hci-spi .. _dtbinding_ambiq_bt_hci_spi: ambiq,bt-hci-spi ################ Vendor: :ref:`Ambiq Micro, Inc. ` Description *********** .. code-block:: none Bluetooth module that uses Ambiq's Bluetooth Host Controller Interface SPI driver (e.g. Apollo4 Blue Plus). Properties ********** .. tabs:: .. group-tab:: Node specific properties Properties not inherited from the base binding file. .. list-table:: :widths: 1 1 4 :header-rows: 1 * - Name - Type - Details * - ``irq-gpios`` - ``phandle-array`` - .. code-block:: none This irq gpio is used to indicate there is packet ready to send to host from controller. * - ``reset-gpios`` - ``phandle-array`` - .. code-block:: none This reset gpio is used to reset the Bluetooth controller. * - ``clkreq-gpios`` - ``phandle-array`` - .. code-block:: none This clkreq gpio is used to send the XO32MHz clock request to host from controller. The host needs to enable XO32MHz when receiving low to high edge interrupts and disable XO32MHz when receiving high to low edge interrupts. .. group-tab:: Deprecated node specific properties Deprecated properties not inherited from the base binding file. (None) .. group-tab:: Base properties Properties inherited from the base binding file, which defines common properties that may be set on many nodes. Not all of these may apply to the "ambiq,bt-hci-spi" compatible. .. list-table:: :widths: 1 1 4 :header-rows: 1 * - Name - Type - Details * - ``reg`` - ``array`` - This property is **required**. See :ref:`dt-important-props` for more information.