.. _decawave_dwm1001_dev: Decawave DWM1001 ################# Overview ******** The DWM1001 development board includes the DWM1001 module, battery connector and charging circuit, LEDs, buttons, Raspberry-Pi and USB connector. In addition, the board comes with J-Link OB adding debugging and Virtual COM Port capabilities. See `Decawave DWM1001-DEV website`_ for more information about the development board, `Decawave DWM1001 website`_ about the board itself, and `nRF52832 website`_ for the official reference on the IC itself. Programming and Debugging ************************* Applications for the ``decawave_dwm1001_dev`` board configuration can be built, flashed, and debugged in the usual way. See :ref:`build_an_application` and :ref:`application_run` for more details on building and running. Flashing ======== Follow the instructions in the :ref:`nordic_segger` page to install and configure all the necessary software. Further information can be found in :ref:`nordic_segger_flashing`. Then build and flash applications as usual (see :ref:`build_an_application` and :ref:`application_run` for more details). Here is an example for the :ref:`hello_world` application. First, run your favorite terminal program to listen for output. .. code-block:: console $ minicom -D -b 115200 Replace :code:`` with the port where the board nRF52 DK can be found. For example, under Linux, :code:`/dev/ttyACM0`. Then build and flash the application in the usual way. .. zephyr-app-commands:: :zephyr-app: samples/hello_world :board: decawave_dwm1001_dev :goals: build flash References ********** .. target-notes:: .. _nRF52832 website: https://www.nordicsemi.com/Products/Low-power-short-range-wireless/nRF52832 .. _Decawave DWM1001 website: https://www.decawave.com/product/dwm1001-module .. _Decawave DWM1001-DEV website: https://www.decawave.com/product/dwm1001-development-board