Edge Impulse: Data forwarder

The Edge Impulse data forwarder sample demonstrates the usage of Edge Impulse’s data forwarder to provide sensor data to Edge Impulse studio when Using Edge Impulse with the nRF Connect SDK. The sample forwards simulated accelerometer data generated by the Simulated sensor driver.

Requirements

The sample supports the following development kits:

Hardware platforms

PCA

Board name

Build target

nRF9160 DK

PCA10090

nrf9160dk_nrf9160

nrf9160dk_nrf9160_ns

nRF5340 DK

PCA10095

nrf5340dk_nrf5340

nrf5340dk_nrf5340_cpuapp_ns nrf5340dk_nrf5340_cpuapp

nRF52 DK

PCA10040

nrf52dk_nrf52832

nrf52dk_nrf52832

nRF52840 DK

PCA10056

nrf52840dk_nrf52840

nrf52840dk_nrf52840

When built for an _ns build target, the sample is configured to compile and run as a non-secure application with Cortex-M Security Extensions enabled. Therefore, it automatically includes Trusted Firmware-M that prepares the required peripherals and secure services to be available for the application.

Overview

The sample periodically performs the following operations:

  • Reads data from sensor. The sample reads simulated acceleration measurements for X, Y, and Z axes.

  • Forwards the data through UART using the protocol specified by Edge Impulse’s data forwarder.

Note

The sample uses UART only to forward the sensor data. For this reason, sample logs are provided through RTT, unlike in other samples.

See Edge Impulse website for more information about the Edge Impulse platform.

Configuration

See Configuring your application for information about how to permanently or temporarily change the configuration.

Setup

Before running the sample, you must complete the following steps:

  1. Prepare your own project using Edge Impulse studio external web tool. See Using Edge Impulse with the nRF Connect SDK for more information about starting using the tool.

  2. Follow the Edge Impulse CLI installation guide to install Edge Impulse command line tools. These tools are needed because the edge-impulse-data-forwarder is used to forward the data received from the device through UART to Edge Impulse studio.

Building and running

This sample can be found under samples/edge_impulse/data_forwarder in the nRF Connect SDK folder structure.

When built as firmware image for the _ns build target, the sample has Cortex-M Security Extensions (CMSE) enabled and separates the firmware between Non-Secure Processing Environment (NSPE) and Secure Processing Environment (SPE). Because of this, it automatically includes the Trusted Firmware-M (TF-M). To read more about CMSE, see Processing environments.

To build the sample with Visual Studio Code, follow the steps listed on the How to build an application page in the nRF Connect for VS Code extension documentation. See Building and programming an application for other building and programming scenarios and Testing and debugging an application for general information about testing and debugging in the nRF Connect SDK.

Testing

After programming the sample to your development kit, test it by performing the following steps:

  1. Run the edge-impulse-data-forwarder Edge Impulse command line tool. The tool connects the device to your Edge Impulse project. See Edge Impulse’s data forwarder documentation for a guide.

  2. Trigger sampling data from the device using Edge Impulse studio:

    1. Go to the Data acquisition tab.

    2. In the Record new data panel, set the desired values and click Start sampling.

      Sampling under Data acquisition in Edge Impulse studio

      Sampling under Data acquisition in Edge Impulse studio

    3. Observe the received sample data on the raw data graph under the panel. For the default sample configuration, you should observe sine waves.

      Sampling example

      Sampling example

Dependencies

This sample uses the following nRF Connect SDK drivers:

In addition, it uses the following Zephyr drivers:

The sample also uses the following secure firmware component: