Testing USB device support

Testing over USPIP in native_posix

A virtual USB controller implemented through USBIP might be used to test the USB Device stack. Follow the general build procedure to build the USB sample for the native_posix configuration.

Run built sample with:

west build -t run

In a terminal window, run the following command to list USB devices:

$ usbip list -r localhost
Exportable USB devices
        1-1: unknown vendor : unknown product (2fe3:0100)
           : /sys/devices/pci0000:00/0000:00:01.2/usb1/1-1
           : (Defined at Interface level) (00/00/00)
           :  0 - Vendor Specific Class / unknown subclass / unknown protocol (ff/00/00)

In a terminal window, run the following command to attach the USB device:

$ sudo usbip attach -r localhost -b 1-1

The USB device should be connected to your Linux host, and verified with the following commands:

$ sudo usbip port
Imported USB devices
Port 00: <Port in Use> at Full Speed(12Mbps)
       unknown vendor : unknown product (2fe3:0100)
       7-1 -> usbip://localhost:3240/1-1
           -> remote bus/dev 001/002
$ lsusb -d 2fe3:0100
Bus 007 Device 004: ID 2fe3:0100