This sample displays a hello message and an incrementing counter using FT800 Embedded Video Engine.
To use this sample, the following hardware is required:
You will need to connect the FT800 EVE SPI interface onto a board that supports Arduino shields.
Building and Running
This sample should work on any board that has SPI enabled and has an Arduino shield interface. For example, it can be run on the nRF52840-DK board as described below:
west build -b nrf52840dk_nrf52840 samples/drivers/misc/ft800 west flash
To build the sample for VM800C board the shield must be defined as described below:
west build -b nrf52840dk_nrf52840 samples/drivers/misc/ft800 -- -DSHIELD=ftdi_vm800c west flash