Bluetooth: Mesh Provisioner
This sample demonstrates how to use the Bluetooth mesh APIs related to provisioning and using the Configuration Database (CDB). It is intended to be tested together with a device capable of being provisioned. For example, one could use the sample in samples/bluetooth/mesh or tests/bluetooth/mesh_shell.
The application provisions itself and loads the CDB with an application
key, then waits to receive an Unprovisioned Beacon from a device. If the
board has a push button connected via GPIO and configured using the
sw0 devicetree alias, the application then waits
for the user to press the button, which will trigger provisioning using
PB-ADV. If the board doesn’t have the push button, the sample will
provision detected devices automatically. Once provisioning is done, the
node will be present in the CDB but not yet marked as configured. The
application will notice the unconfigured node and start configuring it.
If no errors are encountered, the node is marked as configured.
The configuration of a node involves adding an application key, getting the composition data, and binding all its models to the application key.
Please note that this sample uses the CDB API which is currently marked as EXPERIMENTAL and is likely to change.
A board with Bluetooth LE support, or
QEMU with BlueZ running on the host
Building and Running
This sample can be found under samples/bluetooth/mesh_provisioner in the Zephyr tree.
See bluetooth samples section for details on how to run the sample inside QEMU.
For other boards, build and flash the application as follows:
west build -b <board> samples/bluetooth/mesh_provisioner west flash
Refer to your board’s documentation for alternative
flash instructions if your board doesn’t support the