panasonic,amg88xx (on i2c bus)

Vendor: Panasonic Corporation

Description

Panasonic AMG88XX 8x8 (64) pixel infrared array sensor

Properties

Properties not inherited from the base binding file.

Name

Type

Details

int-gpios

phandle-array

Interrupt pin.
The interrupt pin of AMG88XX is open-drain, active low. If connected directly the MCU pin should be configured as pull-up, active low.

This property is required.

supply-gpios

phandle-array

GPIO specifier that controls power to the device.

This property should be provided when the device has a dedicated
switch that controls power to the device.  The supply state is
entirely the responsibility of the device driver.

Contrast with vin-supply.

vin-supply

phandle

Reference to the regulator that controls power to the device.
The referenced devicetree node must have a regulator compatible.

This property should be provided when device power is supplied
by a shared regulator.  The supply state is dependent on the
request status of all devices fed by the regulator.

Contrast with supply-gpios.  If both properties are provided
then the regulator must be requested before the supply GPIOS is
set to an active state, and the supply GPIOS must be set to an
inactive state before releasing the regulator.