sharp,ls0xx (on spi bus)

Vendor: Sharp Corporation

Description

Sharp memory display controller

Properties

Properties not inherited from the base binding file.

Name

Type

Details

extcomin-gpios

phandle-array

EXTCOMIN pin
The EXTCOMIN pin is where a square pulse for toggling VCOM will be given

extcomin-frequency

int

EXTCOMIN pin toggle frequency
The frequency with which the EXTCOMIN pin should be toggled. See datasheet of particular display. Higher frequency gives better contrast while low frequency saves power.

disp-en-gpios

phandle-array

DISPLAY pin
The DISPLAY pin controls if the LCD displays memory contents or white screen. If defined, the pin will be set high during driver initialization. display blanking apis can be used to control it.

spi-max-frequency

int

Maximum clock frequency of device's SPI interface in Hz

This property is required.

duplex

int

Duplex mode, full or half. By default it's always full duplex thus 0
as this is, by far, the most common mode.
Use the macros not the actual enum value, here is the concordance
list (see dt-bindings/spi/spi.h)
  0    SPI_FULL_DUPLEX
  2048 SPI_HALF_DUPLEX

Legal values: 0, 2048

frame-format

int

Motorola or TI frame format. By default it's always Motorola's,
thus 0 as this is, by far, the most common format.
Use the macros not the actual enum value, here is the concordance
list (see dt-bindings/spi/spi.h)
  0     SPI_FRAME_FORMAT_MOTOROLA
  32768 SPI_FRAME_FORMAT_TI

Legal values: 0, 32768

supply-gpios

phandle-array

GPIO specifier that controls power to the device.

This property should be provided when the device has a dedicated
switch that controls power to the device.  The supply state is
entirely the responsibility of the device driver.

Contrast with vin-supply.

vin-supply

phandle

Reference to the regulator that controls power to the device.
The referenced devicetree node must have a regulator compatible.

This property should be provided when device power is supplied
by a shared regulator.  The supply state is dependent on the
request status of all devices fed by the regulator.

Contrast with supply-gpios.  If both properties are provided
then the regulator must be requested before the supply GPIOS is
set to an active state, and the supply GPIOS must be set to an
inactive state before releasing the regulator.

height

int

Height of the panel driven by the controller, with the units in pixels.

This property is required.

width

int

Width of the panel driven by the controller, with the units in pixels.

This property is required.