nRF9160: LwM2M carrier

The LwM2M carrier sample demonstrates how to run the LwM2M carrier library in an application in order to connect to the operator LwM2M network.

Requirements

The sample supports the following development kit:

Hardware platforms

PCA

Board name

Build target

nRF9160 DK

PCA10090

nrf9160dk_nrf9160

nrf9160dk_nrf9160_ns

When built for an _ns build target, the sample is configured to compile and run as a non-secure application. Therefore, it automatically includes Trusted Firmware-M that prepares the required peripherals and secure services to be available for the application.

Building and running

This sample can be found under samples/nrf9160/lwm2m_carrier in the nRF Connect SDK folder structure.

When built as a non-secure firmware image for the _ns build target, the sample automatically includes the Trusted Firmware-M (TF-M).

To build the sample with Visual Studio Code, follow the steps listed on the Building nRF Connect SDK application quick guide page in the nRF Connect for VS Code extension documentation. See Building and programming an application for other building and programming scenarios and Testing and debugging an application for general information about testing and debugging in the nRF Connect SDK.

Testing

After programming the sample and all prerequisites to the development kit, test it by performing the following steps:

  1. Connect the USB cable and power on or reset your nRF9160 DK.

  2. Open a terminal emulator and observe that the kit prints the following information:

    LWM2M Carrier library sample.
    
  3. Observe that the application receives events from the LwM2M carrier library using the registered event handler.

Troubleshooting

Bootstrapping can take several minutes. This is expected and dependent on the availability of the LTE link. During bootstrap, the application will receive the LWM2M_CARRIER_EVENT_LTE_LINK_UP and LWM2M_CARRIER_EVENT_LTE_LINK_DOWN events. This is expected and is part of the bootstrapping procedure. For more information, see the LwM2M carrier library events and Message sequence charts sections in the LwM2M carrier library documentation.

To completely restart and trigger a new bootstrap, the device must be erased and re-programmed, as mentioned in Application integration.

Dependencies

This sample uses the following nRF Connect SDK libraries:

It uses the following sdk-nrfxlib library:

In addition, it uses the following secure firmware component: