Vendor: STMicroelectronics


STM32 Flexible Memory Controller (FMC).

The FMC allows to interface with static-memory mapped external devices such as
SRAM, NOR Flash, NAND Flash, SDRAM...

All external memories share the addresses, data and control signals with the
controller. Each external device is accessed by means of a unique chip select.
The FMC performs only one access at a time to an external device.

The flexible memory controller includes three memory controllers:

  - NOR/PSRAM memory controller
  - NAND memory controller (some devices also support PC Card)
  - Synchronous DRAM (SDRAM/Mobile LPSDR SDRAM) controller

Each memory controller is defined below the FMC DeviceTree node and is managed
by a separate Zephyr device. However, because signals are shared the FMC
device handles the signals and the peripheral clocks. FMC can be enabled
in your board DeviceTree file like this:

&fmc {
    status = "okay";
    pinctrl-0 = <&fmc_nbl0_pe0 &fmc_nbl1_pe1 &fmc_nbl2_pi4...>;


Properties not inherited from the base binding file.






GPIO pin configuration for FMC signals. We expect that the phandles
will reference pinctrl nodes, e.g.

   pinctrl-0 = <&fmc_a0_pf0 &fmc_a1_pf1...>;