atmel,sam0-uart¶
Vendor: Atmel Corporation
Properties¶
Properties not inherited from the base binding file.
Name |
Type |
Details |
---|---|---|
|
|
Receive Data Pinout
This property is required. |
|
|
Transmit Data Pinout
This property is required. |
|
|
Clock frequency information for UART operation
|
|
|
Initial baud rate setting for UART
|
|
|
Set to enable RTS/CTS flow control at boot time
|
Properties inherited from the base binding file, which defines common properties that may be set on many nodes. Not all of these may apply to the “atmel,sam0-uart” compatible.
Name |
Type |
Details |
---|---|---|
|
|
register space
This property is required. See Important properties for more information. |
|
|
interrupts for device
This property is required. See Important properties for more information. |
|
|
Clock gate information
This property is required. |
|
|
name of each clock
This property is required. |
|
|
Optional TX & RX dma specifiers. Each specifier will have a phandle
reference to the dmac controller, the channel number, and peripheral
trigger source.
For example dmas for TX, RX on SERCOM3
dmas = <&dmac 0 0xb>, <&dmac 0 0xa>;
|
|
|
Required if the dmas property exists. This should be "tx" and "rx"
to match the dmas property.
For example
dma-names = "tx", "rx";
|
|
|
Human readable string describing the device (used as device_get_binding() argument)
This property is required. See Important properties for more information. |
|
|
indicates the operational status of a device
Legal values: See Important properties for more information. |
|
|
compatible strings
This property is required. See Important properties for more information. |
|
|
name of each register space
|
|
|
extended interrupt specifier for device
|
|
|
name of each interrupt
|
|
|
phandle to interrupt controller node
|
|
|
number of address cells in reg property
|
|
|
number of size cells in reg property
|
|
|
IO channels specifiers
|
|
|
Provided names of IO channel specifiers
|