Help¶

Build the driver to utilize UART controller Port 1.

Direct dependencies¶

(SERIAL && BOARD_MUSCA_A) || (SERIAL && BOARD_MUSCA_B1) || (SERIAL && SOC_EOS_S3) || (UART_PL011 && SERIAL)

(Includes any dependencies from ifs and menus.)

Defaults¶

y
y
n

Kconfig definitions¶

At <Zephyr>/boards/arm/v2m_musca/Kconfig.defconfig:31

Included via <Zephyr>/Kconfig:8 → <Zephyr>/Kconfig.zephyr:24

Menu path: (Top)

config UART_PL011_PORT1
    bool
    default y
    depends on SERIAL && BOARD_MUSCA_A

At <Zephyr>/boards/arm/v2m_musca_b1/Kconfig.defconfig:28

Included via <Zephyr>/Kconfig:8 → <Zephyr>/Kconfig.zephyr:24

Menu path: (Top)

config UART_PL011_PORT1
    bool
    default y
    depends on SERIAL && BOARD_MUSCA_B1

At <Zephyr>/soc/arm/quicklogic_eos_s3/Kconfig.defconfig:26

Included via <Zephyr>/Kconfig:8 → <Zephyr>/Kconfig.zephyr:25 → <BuildDir>/Kconfig/Kconfig.soc.defconfig:1

Menu path: (Top)

config UART_PL011_PORT1
    bool
    default n
    depends on SERIAL && SOC_EOS_S3

At <Zephyr>/drivers/serial/Kconfig.pl011:18

Included via <Zephyr>/Kconfig:8 → <Zephyr>/Kconfig.zephyr:32 → <Zephyr>/drivers/Kconfig:24 → <Zephyr>/drivers/serial/Kconfig:119

Menu path: (Top) → Device Drivers → Serial Drivers → ARM PL011 UART Driver

config UART_PL011_PORT1
    bool "Enable driver for UART 1"
    depends on UART_PL011 && SERIAL
    help
      Build the driver to utilize UART controller Port 1.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)