-
CONFIG_NRF_SW_LPUART_DEFAULT_TX_TIMEOUT
¶
TX Timeout in milliseconds
Type: int
Help¶
Timeout is used in uart_poll_out and uart_fifo_fill (if interrupt driven API is enabled).
Default¶
1000
Kconfig definition¶
At <nRF>/drivers/serial/Kconfig:23
Included via <Zephyr>/Kconfig:8
→ <Zephyr>/Kconfig.zephyr:9
→ <BuildDir>/Kconfig/Kconfig.modules:1
→ <nRF>/Kconfig.nrf:27
→ <nRF>/drivers/Kconfig:14
Menu path: (Top) → Modules → Nordic nRF Connect → Device Drivers → Low Power UART using REQ/RDY lines
config NRF_SW_LPUART_DEFAULT_TX_TIMEOUT
int "TX Timeout in milliseconds"
default 1000
depends on NRF_SW_LPUART
help
Timeout is used in uart_poll_out and uart_fifo_fill (if interrupt
driven API is enabled).
(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)