CONFIG_SPI_0_OP_MODES

Port 0 supported operation modes (master/slave/both)

Type: int

Help

This sets the supported operation modes at runtime, by the SPI port 0, where: 1 is MASTER mode only (default) 2 is SLAVE mode only 3 is both modes are available.

Direct dependencies

(SPI_XEC_QMSPI && SPI && BOARD_MEC15XXEVB_ASSY6853) || (SPI_0 && SPI)

(Includes any dependencies from ifs and menus.)

Defaults

  • 1

  • 1

Kconfig definitions

At boards/arm/mec15xxevb_assy6853/Kconfig.defconfig:117

Included via Kconfig:8Kconfig.zephyr:26

Menu path: (Top)

config SPI_0_OP_MODES
    int
    default 1
    depends on SPI_XEC_QMSPI && SPI && BOARD_MEC15XXEVB_ASSY6853

At drivers/spi/Kconfig:46

Included via Kconfig:8Kconfig.zephyr:40drivers/Kconfig:34

Menu path: (Top) → Device Drivers → SPI hardware bus support → SPI port 0

config SPI_0_OP_MODES
    int "Port 0 supported operation modes (master/slave/both)"
    range 1 3
    default 1
    depends on SPI_0 && SPI
    help
      This sets the supported operation modes at runtime, by the SPI
      port 0, where:
      1 is MASTER mode only (default)
      2 is SLAVE mode only
      3 is both modes are available.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)