CONFIG_NET_L2_CANBUS_ETH_TRANSLATOR

Enable 6LoCAN to Ethernet translator

Type: bool

Help

Enable a 6LoCAN Ethernet translator. With this translator it is possible to connect a 6LoCAN network to a Ethernet network directly, via a Switch or trough a router. Messages that goes through the translator have a special address and the MAC address is carried inline. The packet is forwarded with uncompressed IPv6 header.

Direct dependencies

NET_L2_ETHERNET && NET_L2_CANBUS && NETWORKING

(Includes any dependencies from ifs and menus.)

Defaults

No defaults. Implicitly defaults to n.

Kconfig definition

At subsys/net/l2/canbus/Kconfig:55

Included via Kconfig:8Kconfig.zephyr:44subsys/Kconfig:22subsys/net/Kconfig:78subsys/net/l2/Kconfig:77

Menu path: (Top) → Networking → Link layer and IP networking support → Link layer options → Enable CANBUS L2 layer [EXPERIMENTAL]

config NET_L2_CANBUS_ETH_TRANSLATOR
    bool "Enable 6LoCAN to Ethernet translator"
    depends on NET_L2_ETHERNET && NET_L2_CANBUS && NETWORKING
    help
      Enable a 6LoCAN Ethernet translator. With this translator it is
      possible to connect a 6LoCAN network to a Ethernet network directly,
      via a Switch or trough a router. Messages that goes through the
      translator have a special address and the MAC address is carried inline.
      The packet is forwarded with uncompressed IPv6 header.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)