CONFIG_I2S_STM32_PLLI2S_PLLR

Division factor for I2S clock

Type: int

Help

Division factor for the I2S clock. PLLR factor should be selected to ensure that the I2S clock frequency is less than or equal to 192MHz. Allowed values: 2-7

Direct dependencies

(I2S && BOARD_96B_ARGONKEY) || (I2S && BOARD_96B_STM32_SENSOR_MEZ) || (I2S_STM32_USE_PLLI2S_ENABLE && I2S_STM32 && I2S)

(Includes any dependencies from ifs and menus.)

Defaults

  • 3

  • 3

  • 7

Kconfig definitions

At boards/arm/96b_argonkey/Kconfig.defconfig:59

Included via Kconfig:8Kconfig.zephyr:26

Menu path: (Top)

config I2S_STM32_PLLI2S_PLLR
    int
    default 3
    depends on I2S && BOARD_96B_ARGONKEY

At boards/arm/96b_stm32_sensor_mez/Kconfig.defconfig:43

Included via Kconfig:8Kconfig.zephyr:26

Menu path: (Top)

config I2S_STM32_PLLI2S_PLLR
    int
    default 3
    depends on I2S && BOARD_96B_STM32_SENSOR_MEZ

At drivers/i2s/Kconfig.stm32:53

Included via Kconfig:8Kconfig.zephyr:40drivers/Kconfig:38drivers/i2s/Kconfig:28

Menu path: (Top) → Device Drivers → I2S bus drivers → STM32 MCU I2S controller driver → Enable usage of PLL

config I2S_STM32_PLLI2S_PLLR
    int "Division factor for I2S clock"
    range 2 7
    default 7
    depends on I2S_STM32_USE_PLLI2S_ENABLE && I2S_STM32 && I2S
    help
      Division factor for the I2S clock.
      PLLR factor should be selected to ensure that the I2S clock
      frequency is less than or equal to 192MHz.
      Allowed values: 2-7

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)