Help¶

Enable Port 2.

Direct dependencies¶

(GPIO_MCUX_IGPIO && BOARD_MIMXRT1010_EVK) || (GPIO_MCUX_IGPIO && BOARD_MIMXRT1015_EVK) || (GPIO_MCUX_IGPIO && (BOARD_MIMXRT1050_EVK || BOARD_MIMXRT1050_EVK_QSPI)) || (GPIO_MCUX_IGPIO && BOARD_MM_SWIFTIO) || (GPIO_MCUX_IGPIO && GPIO)

(Includes any dependencies from ifs and menus.)

Defaults¶

Kconfig definitions¶

At boards/arm/mimxrt1010_evk/Kconfig.defconfig:20

Included via Kconfig:8 → Kconfig.zephyr:26

Menu path: (Top)

config GPIO_MCUX_IGPIO_2
    bool
    default y
    depends on GPIO_MCUX_IGPIO && BOARD_MIMXRT1010_EVK

At boards/arm/mimxrt1015_evk/Kconfig.defconfig:17

Included via Kconfig:8 → Kconfig.zephyr:26

Menu path: (Top)

config GPIO_MCUX_IGPIO_2
    bool
    default y
    depends on GPIO_MCUX_IGPIO && BOARD_MIMXRT1015_EVK

At boards/arm/mimxrt1050_evk/Kconfig.defconfig:31

Included via Kconfig:8 → Kconfig.zephyr:26

Menu path: (Top)

config GPIO_MCUX_IGPIO_2
    bool
    default y if DISK_ACCESS_USDHC1
    depends on GPIO_MCUX_IGPIO && (BOARD_MIMXRT1050_EVK || BOARD_MIMXRT1050_EVK_QSPI)

At boards/arm/mm_swiftio/Kconfig.defconfig:31

Included via Kconfig:8 → Kconfig.zephyr:26

Menu path: (Top)

config GPIO_MCUX_IGPIO_2
    bool
    default y if DISK_ACCESS_USDHC1
    depends on GPIO_MCUX_IGPIO && BOARD_MM_SWIFTIO

At drivers/gpio/Kconfig.mcux_igpio:20

Included via Kconfig:8 → Kconfig.zephyr:40 → drivers/Kconfig:30 → drivers/gpio/Kconfig:28

Menu path: (Top) → Device Drivers → GPIO Drivers → MCUX IGPIO driver

config GPIO_MCUX_IGPIO_2
    bool "Port 2"
    depends on GPIO_MCUX_IGPIO && GPIO
    help
      Enable Port 2.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)