CONFIG_ETH_SAM_GMAC_PHY_ADDR

GMAC PHY Address

Type: int

Help

GMAC PHY Address as used by IEEE 802.3, Section 2 MII compatible PHY transceivers. If you have a single PHY on board it is safe to leave it at 0 which is the broadcast address.

Direct dependencies

ETH_SAM_GMAC && NET_L2_ETHERNET

(Includes any dependencies from ifs and menus.)

Default

  • 0

Kconfig definition

At drivers/ethernet/Kconfig.sam_gmac:169

Included via Kconfig:8Kconfig.zephyr:40drivers/Kconfig:16drivers/ethernet/Kconfig:28

Menu path: (Top) → Device Drivers → Ethernet Drivers → Atmel SAM Ethernet driver

config ETH_SAM_GMAC_PHY_ADDR
    int "GMAC PHY Address"
    default 0
    depends on ETH_SAM_GMAC && NET_L2_ETHERNET
    help
      GMAC PHY Address as used by IEEE 802.3, Section 2 MII compatible PHY
      transceivers. If you have a single PHY on board it is safe to leave it
      at 0 which is the broadcast address.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)