Help¶

This option is useful if one needs to manage SPI CS through a GPIO pin to by-pass the SPI controller’s CS logic.

Direct dependencies¶

(BOARD_REEL_BOARD && NETWORKING && SHIELD_LINK_BOARD_ETH) || (BOARD_REEL_BOARD && NETWORKING && SHIELD_LINK_BOARD_ETH) || (ETH_ENC424J600 && NET_L2_ETHERNET)

(Includes any dependencies from ifs and menus.)

Defaults¶

y
y

Kconfig definitions¶

At boards/shields/link_board_eth/boards/reel_board.defconfig:6

Included via Kconfig:8 → Kconfig.zephyr:24 → boards/shields/link_board_eth/Kconfig.defconfig:17

Menu path: (Top)

config ETH_ENC424J600_0_GPIO_SPI_CS
    bool
    default y
    depends on BOARD_REEL_BOARD && NETWORKING && SHIELD_LINK_BOARD_ETH

At boards/shields/link_board_eth/boards/reel_board.defconfig:6

Included via Kconfig:8 → Kconfig.zephyr:26 → boards/shields/link_board_eth/Kconfig.defconfig:17

Menu path: (Top)

config ETH_ENC424J600_0_GPIO_SPI_CS
    bool
    default y
    depends on BOARD_REEL_BOARD && NETWORKING && SHIELD_LINK_BOARD_ETH

At drivers/ethernet/Kconfig.enc424j600:37

Included via Kconfig:8 → Kconfig.zephyr:40 → drivers/Kconfig:16 → drivers/ethernet/Kconfig:25

Menu path: (Top) → Device Drivers → Ethernet Drivers → ENC424J600C Ethernet Controller

config ETH_ENC424J600_0_GPIO_SPI_CS
    bool "Manage SPI CS through a GPIO pin"
    depends on ETH_ENC424J600 && NET_L2_ETHERNET
    help
      This option is useful if one needs to manage SPI CS through a GPIO
      pin to by-pass the SPI controller's CS logic.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)