CONFIG_UART_0_NRF_UARTE

nRF UARTE 0

Type: bool

Help

Enable nRF UART with EasyDMA on port 0.

Direct dependencies

HAS_HW_NRF_UARTE0 && !(SOC_SERIES_NRF91X && (SPI_0 || I2C_0)) && <choice: UART Port 0 Driver type>

(Includes any dependencies from if’s and menus.)

Kconfig definition

At drivers/serial/Kconfig.nrfx:34

Included via Kconfig:10Kconfig.zephyr:35drivers/Kconfig:22drivers/serial/Kconfig:93

Menu path: (top menu) → Device Drivers → Serial Drivers → nRF UART nrfx drivers → UART Port 0 Driver type

config UART_0_NRF_UARTE
    bool
    prompt "nRF UARTE 0" if HAS_HW_NRF_UARTE0 && !(SOC_SERIES_NRF91X && (SPI_0 || I2C_0)) && <choice: UART Port 0 Driver type>
    select NRF_UARTE_PERIPHERAL if HAS_HW_NRF_UARTE0 && !(SOC_SERIES_NRF91X && (SPI_0 || I2C_0)) && <choice: UART Port 0 Driver type>
    depends on HAS_HW_NRF_UARTE0 && !(SOC_SERIES_NRF91X && (SPI_0 || I2C_0)) && <choice: UART Port 0 Driver type>
    help
      Enable nRF UART with EasyDMA on port 0.

(Definitions include propagated dependencies, including from if’s and menus.)