CONFIG_I2S_SAM_SSC_0_PIN_RF_EN

RF pin enabled

Type: bool

Help

If enabled RF signal is connected to RF pin. It will be configured as an output or an input depending on whether the receiver is working in master or slave mode.

If disabled RF signal is disconnected from RF pin and connected internally to TF (Transmitter Frame Synchro signal).

Direct dependencies

I2S_SAM_SSC && I2S

(Includes any dependencies from if’s and menus.)

Defaults

Kconfig definition

At drivers/i2s/Kconfig.sam_ssc:65

Included via Kconfig:10Kconfig.zephyr:35drivers/Kconfig:42drivers/i2s/Kconfig:29

Menu path: (top menu) → Device Drivers → I2S bus drivers → Atmel SAM MCU family I2S (SSC) Bus Driver

config I2S_SAM_SSC_0_PIN_RF_EN
    bool
    prompt "RF pin enabled" if I2S_SAM_SSC && I2S
    default "y" if I2S_SAM_SSC && I2S
    depends on I2S_SAM_SSC && I2S
    help
      If enabled RF signal is connected to RF pin. It will be configured as
      an output or an input depending on whether the receiver is working
      in master or slave mode.

      If disabled RF signal is disconnected from RF pin and connected
      internally to TF (Transmitter Frame Synchro signal).

(Definitions include propagated dependencies, including from if’s and menus.)